top of page
Blog: Blog2
dj1220131

How to Determine if You Have a Slab Leak


Introduction

As a content homeowner, you take great satisfaction in keeping up with maintenance needs. Have you clogged the plumbing fixture? You slithered and plunged until it parted. Is the dishwasher broken? You quickly installed a brand-new one after lugging that one out on your own.

However, slab leaks are one small surprise that you could not expect. This type of leak is more covert and difficult to spot. It might also result in significant problems for your house.

Slab leaks, however, do not fall under the DIY category. That means you will need to remove your toolbelt for this one. Slab leaks can cause major damage. However, you can detect warning indicators, which makes slab leak detection in Vista much easier.

What is a Slab Leak?

A leak in the water pipes made of copper, run beneath your home’s concrete foundation is referred to as a slab leak. The leaks above are pinhole leaks in walls or ceilings above ground. Such leaks are frequently caused by copper pipes that have been corroded over time.

You may discover slab leaks on your foundation’s drainage systems or water pressure. Usually, if the leaky slab is located on the water system’s pressure side, it can be found before causing significant damage. These leaks can result in serious harm, even though they are typically discovered quickly. Drainage-side leaks can be much more subtle, which makes them more difficult to find. They may seep for a very long time without giving any outward signs.

If slab leaks are not repaired, they can eventually harm cabinets, drywall, hardwood floors, and carpets. Even mold and fungal issues can arise from unchecked moisture for more than twenty-four hours. This can be prevented by having the plumbing inspected regularly. A qualified specialist should do the inspection. The specialist should be experienced in slab leak detection in Vista.

Signs of Slab Leak

  • Water bills suddenly skyrocketing regardless of the amount you use hasn’t changed

  • Low water pressure due to a foundation leak

  • Bad smell coming from the walls or floors

  • Though there are no running taps, you can hear the tickling of taps

  • The once-luxurious lawn is becoming uneven.

  • Multiple fissures within the foundation

  • Worn, wet, and heated floors

What Causes a Slab Leak?

Corrosion

Recall our statement that hot water lines are typically the cause of slab leaks. This is because these lines experience higher rates of corrosion. The pipe may start to corrode from the outside due to a reaction between the water’s heat and the substance encircling it.

It’s important to note that corrosion occurs more frequently in hot water pipes, but it can also occur in cold water lines.

Pipe corrosion affects older homes more frequently than it does contemporary ones. Older homes usually have copper or stainless steel galvanized pipes in their foundations. Despite being resistant to corrosion, copper can corrode, particularly when electrolysis is applied to it.

Call the experts in slab leak detection in Vista immediately if you find such leaks occur due to corrosion.

Pressure on the Pipes

Increased pressure on the water lines beneath your home’s foundation is the main cause of slab leaks. Numerous factors, such as poor initial construction or shifting soil that causes the home’s foundation to move, can result in this kind of pressure. This may result in issues such as ground-level flooding and the deterioration of any building materials.

Abrasion

Water flows through pipes, which naturally expand and contract. Based on how your home was constructed, this expansion and contraction may cause issues. If the pipes don’t have sufficient space to grow and come into contact with concrete, gravel, and possibly other pipes, they may begin to rub against them and eventually wear down.


0 views0 comments

Comments


bottom of page