One of the most common plumbing problems that San Diego residents—or anyone else—experience is a leaking sink.
Water leaks in San Diego can pose a serious threat to your home and even your family if neglected for a long time. If it’s a leak under the kitchen sink, the damage may concentrate on the cabinet, the walls, and the floors.
Interestingly, the leak under the kitchen sink is not as tough to fix as it may sound. Therefore this article will go over tips you can use in repairing a leak under your kitchen sink, Read on!
Identifying the Source of the Leak
Before you can fix a leak in the kitchen sink, you must identify its cause. Here are some steps you can take to identify the source of the leaking sink:
Turn off the water supply
Before you start looking for the source of the leak, turn off the water supply to the sink. Typically, the shut-off valve is found below the sink.
Check the drain pipes
The drain pipes are frequently to blame for kitchen sink leaks. Check the pipes for any moisture or water stains. Tighten the connections or replace the damaged parts if moisture is found.
Check the water supply lines
Another common place where kitchen sink dripping occurs is in the water supply lines. Look for any indications of moisture or water in the lines. If any moisture is discovered, tighten the connections or replace the broken components.
Check the sink basin
At times, even the sink basin itself may leak. Check the caulking around the edges of the sink for any openings or cracks. Scrape off any old caulking you discover, then caulk the edges again.
Check the faucet
Kitchen sink leaks can also originate from the faucet. For any indications of water or moisture, inspect the connections between the faucet and the sink. Tighten any loose connections and replace any damaged components, if any, immediately.
Fixing a Faucet Leak
With a few common tools, repairing a faucet leak is a relatively easy task. Start by cutting off the sink’s water supply. The shut-off valve is typically found in the basement or under the sink.
Use a screwdriver to next remove the faucet’s handle. With a wrench, loosen the packing nut and take out the stem assembly.
An O-ring ought to be visible at the assembly’s base. Reassemble the faucet after replacing the O-ring with a fresh one of the same size. Restart the water supply and look for any leaks in the faucet.
Comments